Skip to main content
Sync Uptime Kuma alert events to Flashduty through webhook.

In Flashduty On-call

You can get the integration push URL in either of the following ways.

Use a dedicated integration

Choose this option if all alerts go to one channel. It’s the simpler setup.
  1. In the Flashduty console, select Channel and open a channel
  2. Select Configuration → Integrations → Private integration, then click Add integration
  3. Select Uptime Kuma integration and click Save to generate a card
  4. Open the generated integration card and copy the Push URL

Use a shared integration

Choose this option if you need to route alerts to different channels based on the alert payload.
  1. In the Flashduty console, go to Integration Center → Alert Events
  2. Select Uptime Kuma integration:
    • Integration Name: Define a name for this integration
  3. Configure the default route and select a channel. You can add more rules under Routing after creation
  4. Click Save and copy the generated Push URL

In Uptime Kuma

1

Set up the notification channel in Uptime Kuma

Where: Uptime Kuma › Settings › NotificationsClick Setup to edit, fill in the fields below, then submit and save:drawing
2

Enable the notification on your monitors

Where: Uptime Kuma › Add New Monitor › Notifications
  1. Click Add New Monitor or edit existing monitors, configure monitoring settings as needed
  2. Enable the notification method created in the previous step in the Notifications section
  3. If needed, add Tags. Note that only tags with both Key/Value will be pushed to Flashduty
  4. Submit and save
drawing
3

Trigger a real alert and verify

Make a monitor that has this notification enabled actually fail (for example, pause the monitored service) and wait for Uptime Kuma to send the alert, then restore the service and confirm the alert recovers in Flashduty (Uptime Kuma sends a recovery event when the monitor goes Up). Back in Flashduty, the integration shows Latest event time, which means setup works.

Status and severity

When a monitor goes Down, the alert severity comes from the Severity set on the notification channel (table below); when it goes Up, a recovery event closes the alert of the same monitor.Uptime Kuma to Flashduty alert severity mapping: