Skip to main content
Sync Zilliz alert events to Flashduty through webhook.

In Flashduty On-call

You can get the integration push URL in either of the following ways.

Use a dedicated integration

Choose this option if all alerts go to one channel. It’s the simpler setup.
  1. In the Flashduty console, select Channel and open a channel
  2. Select Configuration → Integrations → Private integration, then click Add integration
  3. Choose Zilliz integration and click Save to generate a card
  4. Open the generated integration card and copy the Push URL

Use a shared integration

Choose this option if you need to route alerts to different channels based on the alert payload.
  1. In the Flashduty console, go to Integration Center → Alert Events
  2. Select Zilliz integration:
    • Integration Name: Define a name for this integration
  3. Configure the default route and select a channel. You can add more rules under Routing after creation
  4. Click Save and copy the generated Push URL

In Zilliz

1

Create an alert in Zilliz Cloud and add a webhook channel

Where: Zilliz Cloud console › Project Alerts › Alert Settings › + Alert (to change an existing alert, click Edit in the Actions column)You must be an organization owner or a project admin.Click Save or Create to complete the configuration.drawing
2

Test and confirm with a real alert

Where: Zilliz Cloud console › Project Alerts › Alert Settings › alert edit page › Send toNext to the webhook channel there is a Send Test Message icon, which confirms the push URL is reachable. A test message may not carry every field of a real alert, so whether it creates an event in Flashduty depends on the actual result; verify trigger and recovery with a real alert as well.After a few seconds, go back to Flashduty. If the integration shows a Latest event time, the setup works.

Status and severity

When status is NOT_TRIGGERED, Flashduty treats the event as a recovery (Ok) and closes the matching alert.